Petsafe ST-70, 70 m Basic Remote Trainer Manuel d'utilisateur télécharger pdf (Page 7)

www.petsafe.net 7

DENL ITFR ESEN

OPERATING GUIDE

Prepare the Remote Transmitter

To Insert and Remove the Batteries

1. Slide off the battery cover (1A).

2. Install two (2), 3-volt lithium CR2032 batteries positive (+) side up (1B).

3. Slide the battery cover back in place (1C).

To Verify the Batteries are Inserted Correctly

1. Press any button on the Remote Transmitter.

2. The Remote Transmitter LED should ﬂ ash to indicate a button has been pressed.

3. If the Remote Transmitter LED does not ﬂ ash, you may have inserted the batteries backwards.

Try taking them out and turning them over, ensuring that the positive (+) side is up.

4. If the Remote Transmitter LED still does not ﬂ ash, contact the Customer Care Centre.

Risk of explosion if batteries are replaced by an incorrect type. Do

not short circuit, mix old and new batteries, dispose of in ﬁ re, or

expose to water. When batteries are stored or disposed, they must

be protected from shorting. Dispose of spent batteries properly.

Remote Transmitter LED - Function and Response

Function LED Light Response

Unit is on On for length of button press

Low battery condition LED ﬂ ashes 3 times every 5 seconds

STEP 1

1C1A 1B

1 2 3 4 5 6 7 8 9 10 11 12 ... 107 108

Pas de commentaire

Petsafe ST-70, 70 m Basic Remote Trainer Manuel d'utilisateur Page 7