Petsafe YardMax™ Rechargeable In-Ground Fence Add-A-Dog® E Manuel d'utilisateur télécharger pdf (Page 33)

www.petsafe.net 33

In YardMax

™

mode, the

Receiver Collar

corrects when the

pet returns to the

Pet Area.

• Check the YardMax Fence Mode (A/B) Switch is set to A.

• Reverse the wires connected to the Fence Transmitter.

Leave surge protector alone.

• Re-test the boundary.

The Receiver

Collar has to be

held on top of the

Boundary Wire to

activate.

• Charge the Receiver Collar.

• (Traditional Mode only) Adjust Boundary Width Dial

clockwise to increase the distance from the Boundary

Wire that the Receiver Collar activates. Recommended

distance is 10 ft. from Boundary Wire.

• If using a Double Loop, make sure Boundary Wires are

separated by at least 5 feet.

• If the Receiver Collar still has to be held on top of the

Boundary Wire,

refer to YardMax Rechargeable In-Ground

Fence Operating Guide.

The Receiver

Collar activates

inside the house.

• Make sure the Boundary Wire is not running within 15

feet of the house. The signal can transmit through the

walls of your house.

• Make sure Boundary Wires are twisted from Boundary to

the Fence Transmitter.

• (Traditional Mode only) Turn the Boundary Width Dial to

decrease the distance from the Boundary Wire that the

Receiver Collar activates.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Pas de commentaire

Petsafe YardMax™ Rechargeable In-Ground Fence Add-A-Dog® E Manuel d'utilisateur Page 33