Petsafe PIG00-10777 Manuel d'utilisateur télécharger pdf (Page 10)

10 1-800-732-2677

Position the Boundary Wire

Lay out the Boundary Wire using your planned boundary and test the system BEFORE burying the wire or attaching it

to an existing fence. This will make any layout changes easier. Work carefully. A nick in the wire insulation can diminish

the signal strength and create a weak area where your pet can escape.

Running the Boundary Wire parallel to and within 10 feet of electrical wires,

neighboring containment systems, telephone wires, television or antenna cables,

or satellite dishes may cause an inconsistent signal. If you must cross any of these,

do so at 90-degree angles (perpendicularly) (3A).

If separating the wire by at least 10 feet from a neighboring containment system’s

wire does not reduce the inconsistent signal, contact the Customer Care Center at

1-800-732-2677.

To Twist the Boundary Wire

Boundary

Wire

10’

Buried Cable

90°

Twisting the Boundary Wire cancels the signal and allows your pet to cross over that area safely

(3B). The signal cannot be cancelled by running the wire through plastic or metal piping. Using

shielded cable in place of the Boundary Wire will also not cancel the signal. Refer to ﬁgure (3C) for

the correct method of twisting the wire. You can twist your own wire by cutting two equal lengths

of Boundary Wire supplied and twisting them together. Anchor one end of the wires to something

secure and insert the other end in a power drill. Pull the wire taut. The drill enables you to twist

the wire quickly. Twist the Boundary Wire 10 to 12 times per foot to cancel the signal. Once you

have completed your boundary layout, insert the twisted wire into the transmitter.

To Splice or Repair the Boundary Wire

If you need additional Boundary Wire to expand your wire loop, you will need to splice the

wires together. Note the locations of all splices for future reference.

Strip approximately

⁄8 inch of insulation off the ends of the Boundary Wires to be spliced

(3D). Make sure the copper Boundary Wire is not corroded. If the

Boundary Wire is corroded, cut it back to expose clean copper wire.

Insert the stripped ends into the wire nut and twist the wire nut around the wires. Ensure

that there is no copper exposed beyond the end of the wire nut. Tie a knot 3 to 4 inches from

the wire nut (3E). Ensure that the wire nut is secure on the wire splice.

Once you have securely spliced the wires together, open the lid of the gel-ﬁlled splice capsule

and insert the wire nut as deeply as possible into the waterproof gel inside the capsule (3F).

Snap the lid of the capsule shut (3G). For proper system performance, the splice connection

must be waterproof.

If your splice pulls loose, the entire system will fail. Make sure your splice is secure. Additional

gel-ﬁlled splice capsules and wire nuts are available through the Customer Care Center.

TWISTED WIRES

BOUNDARY WIRE

WATERPROOF SPLICE

CORRECT

INCORRECT

3/8"

10 Twists/ft.

Step

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Petsafe PIG00-10777 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les animaux de compagnie Petsafe PIG00-10777