Petsafe PIG00-10777 Manuel d'utilisateur télécharger pdf (Page 14)

14 1-800-732-2677

1. Apply Power to the Fence Transmitter with the supplied Power Adapter.

2. Set the Boundary Width Control Switch (located on the side of the

Fence Transmitter)

(6A)

to the A, B, or C setting based on the total

length of Boundary Wire used.

Setting B is used for most properties.

The

following table will indicate the proper setting.

3. The width of the containment ﬁeld is adjusted using the transmitter’s

Amount of Wire Setting

Greater than 2400 feet A

Up to 1300 feet B

1300 to 2400 feet C

Boundary Width Control knob. Turn the knob counter clockwise until the alarm sounds and the Loop

Indicator Light is no longer lit. Turn the knob clockwise and increase by 2 numbers. The alarm should turn

OFF and the light should turn ON.

The Receiver Collar should not be on your dog when the system is tested. Your pet may receive an

unintended correction.

4. Place battery in Receiver Collar. To identify the Warning and Static Correction Zones make sure the Receiver

Collar is set at level 5 (see Step 5).

5. Test the Boundary Width of the system by selecting a section of straight Boundary Wire that is at least 50 feet

long. Start inside the center of the containment ﬁeld.

6. Place the Test Light Tool Contacts on the Contact Points on the

Receiver Collar (6B,6C). Hold the Receiver Collar at your dog’s

neck height with the Contact Points pointing up (6D) and the

Correction Level Button facing the Boundary Wire. Slowly walk

toward the Boundary Wire until you hear the warning tone

(6E). When you hear the warning tone, you have identiﬁed

the Boundary Width distance (Static Correction Zone).

Two

seconds after the warning tone, the test light will begin to

ﬂash. This ﬂashing light can aid you in identifying the

Test Light Contacts

Boundary Width should you have difﬁculty hearing the tone. To avoid

having the Receiver Collar go into Over Correction Protection mode,

walk back into the Pet Area until the toning stops.

If the Receiver

Collar does not tone at the desired range, adjust the Boundary Width

Control knob to obtain the desired range. Turning the Boundary

Width Control knob clockwise increases the Boundary Width while

turning it counterclockwise decreases

it (6F). Repeat this activity as

needed until the Receiver Collar tones between 6 to 10 feet from

the Boundary Wire. If using a Double Loop layout, you may need to

increase the separation of the Boundary Wire and/or increase the size

of the Boundary Width to achieve the desired range.

Boundary

Wire

7. Test in a number of different locations around the containment area until you are

satisﬁed that the system is functioning properly.

8. Next, walk all around the Pet Area to ensure there are no areas where the Receiver

Collar may activate from signals coupled onto buried wires or cables. Test the collar

in and around the inside of the house as well. As mentioned, cable and wires from

cable TV, electrical or telephone lines may conduct pet fencing signals inside and

outside the house that can activate the dog’s collar accidentally. While rare, if this

occurs your Boundary Wire is probably too close to these outside lines and should

be moved or modiﬁed as shown in Figure (3A).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Petsafe PIG00-10777 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les animaux de compagnie Petsafe PIG00-10777