Petsafe PIG00-10777 Manuel d'utilisateur télécharger pdf (Page 22)

22 1-800-732-2677

Accessories

To purchase additional accessories for your PetSafe

Stubborn Dog In-Ground Fence

™

, contact the Customer Care Center at

1-800-732-2677 or visit our website at www.petsafe.net to locate a retailer near you.

Component Part Number

Battery - 9-Volt Alkaline PAC11-12067

Power Adapter for the Fence Transmitter RFA-372

Surge Protection Kit LP-4100-1

Replacement Collar Strap RFA-41-1

Stubborn Dog Receiver Collar PRF-275-19

Deluxe UltraLight

™

Receiver Collar PUL-275

Additional Boundary Wire RFA-1

Additional Boundary Flags RFA-2

Additional Gel-ﬁlled Capsules and Wire Nuts RFA-366

Wire & Flag Accessory Kit PRFA-500

Accessory Pack RFA-281

Wire Break Locator RFA-450

Troubleshooting

Receiver Collar is not

beeping or correcting.

•Check battery to make sure it is installed properly.

•Check that both lights are lit on the Fence Transmitter. If not, perform the “Transmitter Loop Test” (page 25).

The Receiver Collar is

beeping, but the pet is not

responding to the Static

Correction.

•Test the Receiver Collar with the Test Light walking toward the Boundary Wire.

•If the Test Light ﬂashes, check the ﬁt of the Receiver Collar.

•Trim your pet’s fur where the Contact Points touch the neck and/or purchase longer Contact Points by

contacting the Customer Care Center.

•Increase the Static Correction Level.

•Repeat training steps to reinforce training.

The Receiver Collar has

to be held on top of the

Boundary Wire to activate.

•Replace battery.

•Adjust Boundary Width Control knob clockwise to increase the distance from the Boundary Wire that the

Receiver Collar activates. Verify the Boundary Control Switch is placed at the proper setting according to the

amount of Boundary Wire used. (See Step 6)

•If using a Double Loop, make sure Boundary Wires are separated at least 5 feet.

•If the Receiver Collar still has to be held on top of the Boundary Wire, perform the “System Test” and/or

“Transmitter Loop Test”.

The Receiver Collar

activates inside the house.

•Turn the Boundary Width Control knob counterclockwise to decrease the distance from the Boundary Wire

that the Receiver Collar activates.

•Make sure the Boundary Wire is not running within 15 feet of the house. The signal can transmit through the

walls of your house.

•Make sure Boundary Wires are twisted from Boundary to the Fence Transmitter.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Petsafe PIG00-10777 Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les animaux de compagnie Petsafe PIG00-10777