Petsafe PIG00-10777 Manuel d'utilisateur télécharger pdf (Page 23)

22 1-800-732-2677 www.petsafe.net 23

The Receiver Indicator

Light is ﬂashing every 4 to

5 seconds and I have just

installed a new battery.

•To reset the low battery indicator, remove the battery from the Receiver Collar. Discharge all power by

holding the correction level button down until the light is no longer illuminated. Reinstall battery.

I have an inconsistent

signal.

•Make sure Fence Transmitter is at least 3 feet from large metal objects or appliances.

•Make sure all Boundary Wire turns are gradual with a minimum 3 foot radius.

•Make sure the Boundary Wire is not running parallel to and within 10 feet of electrical wires, neighboring

containment systems, telephone wires, television or antenna cables, or satellite dishes.

•If a neighboring containment system may be causing an inconsistent signal, move the Boundary Wire farther

away from the neighboring containment system.

The Power and Loop

Indicator Lights are off.

•Check that the Power Adapter is plugged into the Fence Transmitter.

•Check that the Power Adapter is plugged in properly.

•If the system is plugged into a GFCI or RCD outlet, check to see if the circuit has been tripped. Reset the

GFCI or RCD circuit if required.

•Verify that the outlet is working properly by plugging in a known working item such as a radio.

•Try plugging into another 120-volt outlet.

•If the lights still do not come on, the Fence Transmitter and/or Power Adapter needs to be replaced. Contact

the Customer Care Center.

•If a Surge Protector is installed, unplug the Surge Protector and plug the power adapter directly into the

outlet. If the Transmitter operates without the Surge Protector, contact the Customer Care Center for a

replacement Surge Protector.

The Power Light is on, the

Loop Indicator Light is off,

and the Fence Transmitter

loop alarm is sounding.

•Check Boundary Wire connections at the Fence Transmitter for proper connection.

•Check for broken or damaged Boundary Wires at outside entry to the house.

•Perform the “Transmitter Loop Test” (page 25) to determine if the Fence Transmitter needs to be replaced.

•If the Fence Transmitter is functioning properly, you have a break in your Boundary Wire. See the “Wire Break

Location Test” (page 25) section in this guide.

Additional Information

• Use care when using a weed eater or when digging near the Boundary Wire to prevent damage.

• The system should only be used with healthy pets. Contact your veterinarian if you have concerns about the medical

condition of your pet (medication, pregnant, heart conditions, etc.).

• The PetSafe

Stubborn Dog In-Ground Fence

™

is for residential use only.

• The Static Correction will get your pet’s attention, but will not cause harm. It is designed to startle, not to punish.

• Test the Receiver Collar at least once a month to verify that it is functioning properly. Check that it activates at the Boundary

Wire. Battery life depends upon how often the Receiver Collar is activated.

• Remove the Receiver collar from your pet when indoors for the comfort of your pet.

• Never leave the Receiver Collar on your pet for more than 12 consecutive hours.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Petsafe PIG00-10777 Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les animaux de compagnie Petsafe PIG00-10777